Terminating Component Editing

The CloseComponent command ends the in-place editing of a Block definition or Reference initiated by the EditComponent command.

To end in-place editing of a Block definition or Reference:

1. Click Modify > Component > Close (or type CloseComponent at the command prompt).
2. In the Component dialog box, click Save to save the changes of the Block definition or Reference you have edited

   - or -

   Click Discard to end Component editing without saving the changes.

  Use SaveComponent to save the changes and end the Component editing session.

Access

Command: CloseComponent

Menu: Modify > Component > Close

Ribbon: Insert > Component > Close Component