-TInsert

Use the -TInsert command to insert Blocks in table cells.

It is the command window variant of the TInsert command.

You can insert:

• Blocks defined in the active drawing
• Blocks defined in external drawing files

To insert a Block in a table cell:

1. Type -TInsert at the command prompt.
2. In the graphics area, select the cell where you want to insert the Block.
3. Type the name of a Block and press Enter.

   You can also specify the ? option to view a list of defined Blocks in the drawing.

4. Specify how to fit the Block within the cell:
   • Yes. Automatically scales the Block to fit the specified cell.
   • No. Lets you specify a scale for the Block. A scale factor of:
     • 1: Inserts the Block at its original size.
     • Less than 1: Reduces the size to the percentage of the original size specified by the factor.
     • Greater than 1: Increases the size.
5. Specify a value to set the rotation angle in the cell.
6. Specify the alignment for the Block within the cell (for example, TL for top left alignment). (Vertical alignment: T = top, M = middle, B = bottom; horizontal alignment: L = left, C = center, R = right).

Access

Command: -TInsert