Working with Leaders, Center Marks, and Geometric Tolerances

Use leader commands to draw leader lines that connect annotations to drawing entities.

There are two types of leaders: MultiLeaders and simple Leaders. MultiLeaders are based on MultiLeaderStyles.

You can create:

• SmartLeaders. SmartLeaders are Leader lines that connect annotations to a drawing entity. Additional formatting features are available.
• Leader Lines. Leader lines are lines that connect annotations to a drawing entity
• MultiLeaders. MultiLeaders are entities consisting of leader lines and a note. MultiLeaderStyles control the way MultiLeaders look.

You can create geometric tolerances to place datum feature symbols and datum targets in drawings.

This section discusses:

• Creating SmartLeaders
• Creating Leader Lines
• Creating MultiLeaders
• Modifying MultiLeaders
• Working with MultiLeaderStyles
• Creating Center Marks
• Creating Geometric Tolerances
• Editing Geometric Tolerances