-InsertBlock¶
Use the -InsertBlock command to insert a Block or another drawing.
It is the command window variant of the InsertBlock command.
To insert Blocks:
Type -Insert at the command prompt.
Type a Block name or specify the ? option to list existing Blocks. To insert a drawing, specify the folder and name of the drawing.
In the graphics area, specify the insertion point for the Block, or specify an option:
Angle. Sets the rotation angle in the graphics area during insertion.
Reference point. Sets a new reference point other than the default insertion point as you drag the Block into position.
Uniform scale. Sets an uniform scale factor for the XYZ axes.
X, Y, and Z. Sets individual scale factors for each axis.
Corner (available after you specify the insertion point). Specifies the X and Y scale by defining the opposite corner of a rectangle (where the insertion point is the base point of the rectangle). Then you specify the Z scale.
If the Block has BlockAttributes, edit the attributes.
Access
Command: -InsertBlock
Related Topics