3D Viewing Using Vertical Orbit¶
Use the RollViewVertical command to tilt the view of your model vertically about an imaginary horizontal axis.
To view the model in 3D using vertical orbit:
Do one of the following:
On the menu, click View > 3D Orbit > Vertical Orbit.
On the ribbon, click View > Render > Vertical Orbit
.
Type RollViewVertical.
In the graphics area, drag the pointer.
A green pivot point
appears in the center of the model. If you selected entities before you entered Constrained Orbit mode, the pivot point appears at the center of the selected entities.Note: The arcball feature is not available in this Constrained Orbit mode.
Press Esc or Enter to exit Constrained Orbit mode.
Access
Command: RollViewVertical
Menu: View > 3D Orbit > Vertical Orbit
Ribbon: View > Render > Vertical Orbit
Related Topics
3D Viewing Using Horizontal Orbit
3D Viewing Using Constrained Orbit
Parent Topic